Tekin Rs hotwire

[holshane]

anybody know what the best profile setup is for our track in the ss truck class? it is a little confusing

[wild bill replogle]

Ok. First if its new make sure you update to V203. After update disconnect and close out hot wire then re open it. Then calibrate your radio. Its a must after updating software. My car is what Jabber would reffer to as a "land missle" so be prepared.

Make sure you hit the advanced tab to show all settings

Make sure you have it in BL FW for brushless

Rev strength 0
Drag brake 0
Dead band 20
Brake strength 80
Lipo cut off 2
Throttle profile 1
Timming 40
Turbo 10
Turbo delay .5
Ramp rate 2.0
End rpm 15000
Start 4700 (can't remember exactly set as close to)

You have to set your end rpm first then hit calculate then chose your start.

Then apply settings. I like to hit show defaults then current settings cause it does glitch ocasionaly.

I am also running 10* of timing on my motor.

Enjoy!

[WIITA]

I agree with Billy, his truck was freakin fast last week. Only other thing would do different instead of putting profile on bl-fw is go to bl-dl and put your reverse strength to 80. I cant tell you how nice it is to not have to get off the drivers stand everytime your stuck against a pipe when your practicing. Just kick
her into reverse

[holshane]

thanks guys